cmucam3-hardware (#1) - Cmucam 3 Using C++ (#206) - Message List

Cmucam 3 Using C++

Hello, I have now bought an cmucam3 and I have flash it with the ( cmucam2_lpc2106-cmucam3.hex ) from the cc3 dir, Now I can send commands using the CMUcam3 Frame Grabber, but I know c++ well and now Im asking if there exist any libary for this and if someone have any examples.

My ohter question is, I have tryed to flash the board using the spoonbot but it just write out, start.... start.... etc like it crashes, I use 3 Parallax (Futaba) Standard Servos extern voltage input 4.9VCD.

It Drives with an DC that gives 4.9VCD, maybe thats why? I read about the servos runs on minimum 5VCD.. this maybe make the crash or something ?.

I hope someone can point me somewere I love to learn more about this and write my own programs that send commands for my project insted of flash it to the board all the time,

Thanks alot! and Cheers!

xsocom
05/14/08 12:15:11
Tree View Flat View (newer first) Flat View (older first)
  • Message #659

    Noone :S?

    xsocom
    09/23/08 07:28:03
    • Message #679

      It does sound like the processor is browning out. It probably draws too much current causing the voltage to drop too low.

      agr
      10/03/08 01:51:46
Tree View Flat View (newer first) Flat View (older first)